![]() Read carefully the instructions on the screen and press the OK button to continue. Use the UP/DOWN scroll button to select Charging the battery via diagnostic socket option from the Power supply (Battery) menu and press the OK button. This function can delete the transport mode of the control unit and allows the battery charging via the OBDII port. Select the Power down command on the next screen to shut down electronic control units or select ESC to exit without change.Ī screen will appear for your confirmation, press Yes to send the Power Down Command, or press No to exit this function.Īfter the command is sent, follow the instructions on the screen and press OK to continue. Select Activate rest state option from the Power supply (Battery) menu. This function can be used to place electronic control units in sleep mode within a short time. Use the UP/DOWN scroll button to read the complete information and press OK to end this service function. Select Evaluate close-circuit current monitoring button to display the last 24 close-circuit current values. ![]() ![]() Use the UP/DOWN scroll button to select Close-circuit current option from the Power supply (Battery) menu and press the OK button. Battery will discharge at a relatively fast rate even current consumption rates slightly above the normal.Įvaluate Close-circuit Current Monitoring The close-circuit current should always be measured if increased current consumption is suspected. Press the corresponding function buttons and follow the on-screen instructions to perform the desired registration functions. Press to return to the selection screen or press to end the service function. Read carefully the information on the display and press OK to continue.Ĭheck the battery capacity and the battery replacement information on the screen. Select Register battery replacement in the Battery menu.įollow the on-screen instructions and press to display the battery history. If the battery change is not registered, the power management system will not function properly, which may not provide the battery with enough charging power to operate the car and limit the functions of individual electrical consumers. This option allows displaying the mileage reading of last battery replacement, registering the battery replacement after replacing a new battery and informing the power management system that a new battery has been fitted to the vehicle. Read carefully the notice on the screen and press the OK button to continue.Ĭheck the battery charge status histogram and press the OK button to end the service function. Press to display the battery charge status histogram. To display the battery charge status histogram: Read carefully the information on the screen and press OK to continue.Ĭheck the determined battery charge status and press OK to end the service function. Press OK to open the next screen, select to view the charge state of last 5 days. To display the battery charge status of the last 5 days: Select Evaluate state of battery charge in the Battery menu. This function is used for reading the measured data from the power management system, determining the status of the battery charge, and displaying the battery charge status histogram.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |